User Guide

Note: these values have been measured at control unit input and/or on the DC socket.
Battery protection
(SWITCH POSITION)
LOW
MED
HIGH
Cut-out 12V
9.6
10.1
11.1
Cut-in 12V
10.9
11.4
12.4
Cut-out 24V
21.3
22.3
24.3
Cut-in 24V
22.7
23.7
25.7
Do not put hot food items into the refrigerator. Place the products in such a way as to avoid them hitting against
each other or breaking because of the movement of the vehicle.
Make sure that the lid is always well closed and open it for as short a time as possible.
Defrosting is needed when the layer of frost is thicker than 4 mm.
To carry out this operation, turn off the refrigerator.
Do not use sharp or cutting tools to remove the layer of frost or ice.
Wait until complete unfreezing and then turn on again.
Before carrying out any maintenance operation on the refrigerator, take the power cable out of its
socket.
• Regularly clean the inside and outside of the refrigerator using only warm water and a neutral detergent.
• Subsequent to washing, rinse with clean water and dry thoroughly using a soft cloth.
• Do not use the following: special glass and mirror cleaning products, liquid, powder, or spray detergents, alcohol,
ammonia or abrasive products.
• If you are not using the refrigerator, we suggest cleaning it well inside and leaving the door ajar to ven-
tilate the interior.
FILLING
DEFROSTING
MAINTENANCE
CLEANING
In the standby mode, long press " " and " " button for 3 seconds, then enter into battery protection
mode, short press " " or " " to asjust the level, "--" refer to low battery mode, "==" refer to
middle mode, "==" refer to high protection mode.
7