es i r e S J A User’s Manual
CONTENT
SAFETY INFORMATION Please read this operating manual carefully before starting the appliance. Keep it in a safe place for future reference. If the appliance is passed on to another person, this instruction manual must be handed over to the user along with it. The manufacturer cannot be held liable for damage resulting from improper usage or incorrect operation.
DESCRIPITION ENGLISH Please read these instructions and the Safety section carefully before using your refrigerator. 15.0'' (38.0cm) AJ30 Series 13.8'' (35.0cm) 23.0'' (58.5cm) 13.8'' (35.0cm) 23.0'' (58.5cm) 13.8'' (35.0cm) 23.0'' (58.5cm) 17.5'' (44.5cm) AJ40 Series 20.9'' (53.
MODEL AJ30 Serise AJ40 Serise AJ50 Serise 15.0 x 23.0 x 13.8 (inch) 17.5 x 23.0 x 13.8 (inch) 20.9 x 23.0 x 13.8 (inch) 38.0 x 58.5 x 35.0 (cm) 44.5 x 58.5 x 35.0 (cm) 53.0 x 58.5 x 35.0 (cm) Net Weight 28.0 lbs 30.0 lbs 33.1 lbs 12.7 kg 13.6 kg 15.0 kg Storage Volume 31.7 quarts 42.3 quarts 52.8 quarts 30 liters 40 liters 50 liters Voltage DC 12/24V DC 12/24V DC 12/24V Refrigerant R134a R134a R134a Temperature Range -18°C to +10°C (-0.4°F to 50°F) -18°C to +10°C (-0.
HANDLE INSTALLATION X2 Left X 2 Right X 2 X8 step 1 step 2 step 3 4 X1
USE ECO MAX ON/OFF MAX/ECO - Plug in the DC or AC power. Press the button to run the refrigerator. The LED display on the control panel would be lighted and the interior temperature would be displayed. - Press the button and to adjust the temperature. Press the button to increase while the button to decrease the temperature. When press the and at the same time, it would switch the display between °C and °F.
CUT IN / CUT OUT ● Your fridge has built in battery protection and needs a minimum 10.9 V to start and 9.6 V to continue operating. ● During operation a load is placed on the power supply and voltage can drop by as much as 2 V, especially if the wiring in insufficient (less than 6mm direct to battery) or if there is a loose connection somewhere. ● If this occurs when you try and start your SetPower and the power supply drops under 10.9 V it will not start.
Note: these values have been measured at control unit input and/or on the DC socket. Cut-out 12V Cut-in 12V Cut-out 24V Cut-in 24V LOW 9.6 10.9 21.3 22.7 MED 10.1 11.4 22.3 23.7 HIGH 11.1 12.4 24.3 25.7 Battery protection (SWITCH POSITION) In the standby mode, long press " " and " " button for 3 seconds, then enter into battery protection mode, short press " " or " " to asjust the level, "--" refer to low battery mode, "==" refer to middle mode, "==" refer to high protection mode.
SUGGESTIONS Should the device fail to work or work badly, before referring to our after-sales service, make sure that: a) the feeding voltage is not missing; b) the voltage is the same as the one shown on the plate; c) the connections and the polarities are right; d) the airing grids are not covered over; e) the refrigerator unit is not near any heat source; f ) the fuse of the feeding line is not blown.
The power supply cable must be replaced only by qualified technical personnel and in any case by an after sales service authorised by the Manufacturer. SetPower is not liable in any way if you do not comply strictly with all the previsions in this manual.
OUR GUARANTEE SetPower product comes with a 2-year warranty on the compressor and 1 year warranty on all other parts for your peace of mind. In the unlikely event this product fails when used according to our user guide, we will either repair or replace it. For full warranty terms and conditions on this product, please see the user guide. We'd welcome you contact us support@setpowerusa.com if you have any question about the product.
