Operation Manual

39
Menu Operations
6.5 Software Upgrade
When you enter to “Software Upgrade”
menu, you will see a screen like beside:
1. Press [CH▲/▼] to select the wanted
item among Software Upgrade and
Upgrade by Satellite.
2. Press [OK] to enter the selected item.
6.5.1 Software Upgrade
1. This function allows you to upgrade the
software of the receiver. This can be
done from PC to receiver or from a
master receiver to a slave receiver with
one Scart to RS232 adaptor.
2. Connect master receiver or PC to the
slave receiver via RS232 to Scart
adaptor. Enter the “Software Upgrade”
menu of the master receiver and press
[Vol◄/►] to change the upgrade mode. Upgrade modes include: All code /
Main code / CAS-data / Script GUI / Radio Back / default DB / Userdb.
3. Switch on the slave receiver.
4. Mark “Start” on the master reeciver and press [OK] to start upgrade.
Wait until the display on the front panel shows “-END”. Then switch off the
receiver and on again. Now the new software is used.
5. Press [MENU] to save the setting without upgrade.
6.5.2 Upgrade by Satellite
This function can upgrade the software of
your receiver through data sent by a
satellite. At the moment we offer satellite
updates only through ASTRA1 and Hotbird
satellites.