User guide

ST-EG100-E Installation and User Guide Introduction

• Diagnostic Logs available via email

• Omnistat2™ Humidity and Outside Temp. support

• 256 bit AES Encryption and 1024 bit RSA Key

• 30% higher performance processor

• NIST AES Compliant Encryption/Decryption Engine

1.3.2. Specifications

• Operating Voltage - 12 Volts D.C. from Security Panel or optional Plug-in Power

Supply

• Current Draw - Approximately 300 mA

• Circuit Board Dimensions - 2.25" x 3.95"

• Email Recipients - Limited by Service Provider, typically 16 destination for each sent

• Messages - 16 Maximum, limited by ElkRP2

• Email Address Length - 48 Character Maximum through ElkRP2, Unlimited through

Virtual Keypad

• Email Message Length - 255 Character Maximum (Not including embedded reports)

1.4. Controls and Indicators

Table 1 - RJ-45 Network Jack LEDs

LED Indicators Description Normal State

Orange Processor Power Indicator On-Solid

Green Network Traffic Indicator On-Blinking

During a reboot, the green light will be off and the orange light will be on for 30-45 seconds.

When the reboot is complete, both lights will turn off for a second, and then the orange light will

come on solid and the green light will begin to blink. Wait several seconds before re-establishing a

connection with the control.

SETECH Security & Automation Revision 1

96-300001 Page 5 of 44