User guide

ST-EG100-E Installation and User Guide Introduction
Chapter 1 Introduction
1.1. Description
The SETECH™ ST-EG100-E™ advanced Ethernet Gateway provides an Ethernet network
connection to the ELK-M1™ Family of Control Panels using TCP/IP protocol for configuration
programming (ElkRP2™), web services, remote access via Virtual Keypad, and Enhanced Email
Notification (EEN). Remotely access the advanced featured “Virtual Keypad” over a secure
connection (HTTPS) with any modern web browser running on a desktop or mobile device,
including iOS™ and Android™ web browsers (no additional application required). The Virtual
Keypad provides automation access to lighting and climate control, including relative humidity
and outside temperature sensors on Omnistat2. EEN provides embedded dynamic reports (Zone
Status, Zone Alarm and Area Status) to multiple email recipients using standard and encrypted
SMTP email services.
1.2. Elk™ M1XEP™ Compatibility
• Configuration and firmware updated through ElkRP2
• M1toGO™, eKeypad™, myKeypad™ and MobiLinc™
• Secure encryption - password authentication
• Dynamic DNS (DDNS) support
• DHCP protocol configuration
• SNTP Time Server Support
• RS-232, DB9M 9-Pin serial port connection
• RJ45 8-pin Network Jack
• 2.1 mm Barrel power connector (center positive)
• 802.3 compliant 10/100 Mbit network Interface
1.3. Features and Specifications
1.3.1. Advanced Features
• iOS and Android™ compatible embedded “Virtual Keypad”
• Secure Web Server (HTTPS)
• Enhanced Email Notification (EEN) with embedded reports
• Secure SMTP Email support (Gmail compatible)
• HTML Email support
• Email Distribution List (multiple destination addresses)
SETECH Security & Automation Revision 1
96-300001 Page 4 of 44