User guide

ST-EG100-E Installation and User Guide Virtual Keypad
• More... - Allows the user to scroll messages displayed on the first line of the alpha-
numeric display. This button has no effect if the status consists of a single line.
• Function Buttons
o F1 thru F6 - Executes the pre-configured function associated with the
key.
o Exit – Illuminates when the system is ARMED in AWAY Mode. If
configured to act as a control within ElkRP2, this button will place the
system in “Away” mode. Subsequent clicks during the arming process will
place the system in the next configured exit mode.
o Stay – Illuminates when the system is ARMED in STAY Mode. If
configured to act as a control within ElkRP2, this button will place the
system in “STAY” mode. Subsequent clicks during the arming process
will place the system in the next configured stay mode.
4.4.2. Lighting Page
The lighting interface shows the current state of the defined lighting devices that have their
“Show” state set within ElkRP2 and allows setting of the lighting state. The current lighting state
is shown by an ON/OFF indicator that illuminates green when the light is on and gray if the light
is off. In addition, a sliding scale is shown to indicate the current selected light level – from 0%
to 100%.
The current light state can be changed by clicking on the ON/OFF indicator or dragging the
slider control. When clicking on the indicator, the light will toggle from on to off or off to on.
When the light is toggle on, it will be at 100% level. Moving the slider will directly set the light
level to the relative slider position.
SETECH Security & Automation Revision 1
96-300001 Page 29 of 44