User guide

ST-EG100-E Installation and User Guide Virtual Keypad
Figure 9 - User Code Entry
The only valid characters are the number 0 through 9. All other entries are to be ignored. The
login process is initiated by the Connect button or pressing Enter. On failure, a message is
displayed that indicates a general failure, and the entered user code must be re-entered.
4.4. Security System Interface
After successfully authentication by the Elk M1 security panel, the user is presented with the
Virtual Keypad - Security tab keypad interface.
4.4.1. Security Page
The Security interface displays overall system status and provides many of the operations that
are available from a physical keypad. Selections are available for choosing the “Area” and
“Keypad” configured on the security panel.
The area selection allows selecting the area to display and control. Areas restrictions are based
on the user code entered to initially access the keypad interface. By default, information for the
first authorized area is displayed. The active area can be changed by selecting from the “Area”
option menu.
The keypad selection allows for selecting any named keypad assigned to the currently selected
area. The selection of a keypad gives access to that keypad’s defined function key (F-key)
operations.
SETECH Security & Automation Revision 1
96-300001 Page 26 of 44