User guide

ST-EG100-E Installation and User Guide Virtual Keypad
Chapter 4 Virtual Keypad
4.1. Virtual Keypad Access
To access the Virtual Keypad Locally (on the same network), simply enter the IP Address for the
ST-EG100-E located in the System URL/IP field on the Account Details page of ElkRP2,
Example http://192.168.1.15. By default, this entry is routed to port 80, therefore, explicitly
specifying port 80 is not required.
If accessing the Virtual Keypad from the internet (outside the local network), you must open port
80 (port forward). See section 3.5 for additional information for setting up your internal router.
4.2. Web Login
The first page of the Virtual Keypad is the Web Login Authentication Page. This login
authentication is performed by the ST-EG100-E and acts as a firewall, preventing unauthorized
access to the Elk M1 Control. Usernames and Passwords are configured on the Password tab of
the M1XEP setup screen of the ElkRP2. By checking the “Save Login Information” box,
following the initial entry of a valid Username and Password, this screen will be bypassed.
Figure 8 - User Authentication
4.3. Security Panel Login
After successfully entering the web login, the next page displayed is the security panel login.
This login is required to successfully connect to the security panel. The user code is a 4-digit or
6-digit (system dependent) code as defined in the Users folder of ElkRP2. This code is validated
by the security panel and the available features presented in subsequent pages are dependent on
the defined user code capabilities.
SETECH Security & Automation Revision 1
96-300001 Page 25 of 44