User guide

ST-EG100-E Installation and User Guide Configuration
SETECH Security & Automation Revision 1
96-300001 Page 24 of 44
The table below lists the ports used by the Elk M1XEP that should be port forwarded through the
router.
Port Use Routing Protocol
2601
Encrypted communications port.
Configurable by installer.
2601 is the default.
Route outside to connect with
ElkRP2 and web TCP browser
through Internet/WAN.
TCP
21 Elk M1XEP Firmware Updates
Route outside if ElkRP2 will
connect through FTP or TCP
Internet/WAN to download
firmware updates to the Elk
M1XEP
FTP or TCP
80
8080
Web Browser
Route outside to connect with
web browser TCP through
Internet/WAN.
TCP
443
8443
Web Browser (encrypted)
Route outside to connect with
web browser TCP through
Internet/WAN.
TCP
3.5.2. Other Ports Used by the Elk M1XEP
The following table contains additional ports used by the M1XEP. These ports should not be
opened (port forwarded) outside the local network.
Port Use Protocol
2362
The Elk M1XEP listens on this port to respond to a "FIND"
Command.
UDP
2101
Plain text communications port. Configurable by installer. 2101 is
default
TCP