User guide

ST-EG100-E Installation and User Guide Configuration
• The filter criteria consists of zone references by zone numbers and/or zone status
values by name.
• Zone numbers may be specified as comma separated individual numbers or ranges.
• Ranges are specified as a starting number and ending number separated by a '-'
(dash).
• Zones are numbered from 1 to 208. A zone number value or range must be specified.
For all zones, use 1-208.
• The accepted zone status filters are ALL, NORMAL, TROUBLE, VIOLATED, and
BYPASSED.
• Multiple zone status filters may be used, separated by a comma. If no zone status
filter value is specified, ALL is assumed.
Example ranges:
1,4-7,12 only zone numbers 1,4,5,6,7, and 12 are to be reported
Example filter including zone status filtering:
1-208,VIOLATED report only violated zones in the range 1 through 208
1,4-6,BYPASSED,VIOLATED report bypassed or violated for zones 1,4,5, and 6
Syntax for each given example:
{ZS=1,4-7,12} or {ZONE_STATUS=1,4-7,12}
{ZS=1-208,VIOLATED} or {ZONE_STATUS=1-208,VIOLATED}
{ZS=1,4-6,BYPASSED,VIOLATED} or {ZONE_STATUS=1,4-6,BYPASSED,VIOLATED
3.5. Router Setup Notes
3.5.1. Port Forwarding
Particular ports must be opened through the router to allow access to the M1XEP through the
Internet. You must access the router's setup in order to open (port forward) these ports. The
method for this differs from product to product. Some routers use a software utility to access
their setup while others can be accessed via a web browser. Consult the router's documentation
for complete instructions on this procedure.
SETECH Security & Automation Revision 1
96-300001 Page 23 of 44