User guide
ST-EG100-E Installation and User Guide Configuration
3.4. Optional Configuration Using ElkRP2
3.4.1. Setup of User Names & Passwords
If you will be remotely connecting to the M1 Control via a web browser (Virtual Keypad), it is
REQUIRED that you assign at least one user names with passwords to protect against
unauthorized access to the M1 Control from the Web Brower. In addition, third party software
developers wishing to connect to the ST-EG100-E secure port typically use the user name and
password function.
1. Connect to the ST-EG100-E from ElkRP2.
2. Activate the Passwords tab in the M1XEP Setup window.
3. Enter up to eight (8) different User names and Passwords. Each entry may be up to 16
alphanumeric characters in length.
4. Activate the Send button to save User Names & Passwords configuration changes to the ST-
EG100-E. Refer to steps 15 through 19 of Section 3.3 for instructions on sending changes to
ST-EG100-E and saving to local ElkRP2 database.
3.4.2. Setup Email Notification
To be notified via email for defined events (e.g. system disarmed by a specific user), setup email
notification as follows:
1. Connect to the ST-EG100-E from ElkRP2.
2. Activate the Email tab in the M1XEP Setup window.
3. Enter the outgoing SMTP server’s URL or IP address in the “Server URL/IP Address” field
(e.g. smtp.gmail.com). This field supports a maximum entry of 48 characters.
4. In the “Port” field, enter the port for the outgoing mail server. The default port setting is 25.
If necessary, contact your network administrator or Internet provider to request the correct
port setting.
5. Enter a valid
email address in the “FROM email address” field. This email address appears
in all email messages generated by the ST-EG100-E.
6. If required by your Internet Service Provider, enter the “Username” and “Password” to log
onto the outgoing email server in the corresponding fields; otherwise, leave these fields
blank.
7. Define Email Addresses and corresponding messages in the table in the lower portion of the
window. The ElkRP2 supports up to 16 addresses and messages. The maximum length of
SETECH Security & Automation Revision 1
96-300001 Page 16 of 44