User guide

ST-EG100-E Installation and User Guide Configuration
between 1024 and 49151, with the recommended (default) being 2101. For security reasons,
this port should not be mapped outside the local network. If the port is not needed, disable by
deselecting Enable Non-Secure Port.
14. ElkRP2 and some third party devices use a SSL or secure port for encrypted
communications. Enter the appropriate value for the secure port number in the field
immediately below (see Figure 4). Valid entries are between 1024 and 49151, with the
recommended (default) being 2601. In order to remotely access the M1 Control from the
Internet, your router must be configured to map this port (port forwarded). Refer to
documentation for your router to configure port forwarding.
Figure 4 – ElkRP2 TCP/IP Settings
15. Activate the Send button to save network configuration changes to the ST-EG100-E and the
system displays the M1XEP Reboot Required dialog box (see Figure 5).
Figure 5 - Reboot Required Dialog Box
16. Activate Yes button to continue and the system displays a series of messages in a pop up
window of the items being sent to the ST-EG100-E. Once all items have been saved, the
system displays the M1XEP Reboot Required confirmation dialog box (see Figure 6).
SETECH Security & Automation Revision 1
96-300001 Page 14 of 44