User guide

ST-EG100-E Installation and User Guide Configuration
If no device is listed, activate the Search button to repeat search process. If a device is still
not listed, verify hardware was properly installed and enrolled per Section 2.1.
Figure 2 – ElkRP2 Find Results
4. Verify the listed MAC address for the device matches the MAC address printed on the label
on top of the RJ45 connector on the ST-EG100-E (see Figure 3). If not, repeat the
Find/Search function described in step 3.
Figure 3 - MAC Address Label Example
If the router on the LAN is serving DHCP and the ST-EG100-E is set for DHCP, a dynamic
IP address is assigned to the ST-EG100-E by the router. This address is used to communicate
with the ST-EG100-E.
NOTE: If router DHCP server is disabled or unavailable, the ST-EG100-E defaults to the
previously configured static IP address or, if no static address was previously configured, the
factory default IP address of 192.168.0.251.
5. Highlight (left-click) the ST-EG100-E device to configure and activate the Use Selected
button to copy the IP address and Port settings into the corresponding System URL/IP and
Port fields in the ElkRP2 Account Details panel. The system closes the Find M1XEPs
window. You should now be able to communicate with the M1 Control.
6. Activate Close button in the M1XEP Setup window to close window.
7. In the Account Details panel, verify the System URL/IP, Port, Serial Number and the RP
Access Code fields are correct for the M1 Control. The default RP Access Code is 246801.
8. Select Network from the Connection pull-down menu located at the top of the ElkRP2
window. The system displays a series of messages in a pop up window starting with
“Connecting to account using Network” and finishing with “Connecting: verifying system
identity”.
SETECH Security & Automation Revision 1
96-300001 Page 12 of 44