Specifications

If a tank is not installed that tank indicator will always show empty (no level

segments will be shown).

When full, all level segments are shown.

When empty, the bottom level segment flashes and the other segments are not

shown.

Note: If the pump switch is off, the water level displays are not updated; they

continue to show the levels from the last time the pump switch was on.

Waste Water Tank

This indicates the approximate level in the waste water tank.

If the tank is not installed the indicator will always show full (all level segments will

be shown).

When full, all level segments are shown and flashing.

When empty, only the bottom level segment is shown.

Note: If the pump switch is off, the display is not updated; it continues to show the

level from the last time the pump switch was on.

Battery Volts Low

This indicator shows when the battery voltage is at or below 11.0 Volts.

This is user settable, refer to Advanced Configuration section.

Battery Off

This indicator is displayed when switch is in the off position.

Water Pump Off

This indicator is displayed when the water pump switch is in the off position.

Description of Switches and Buttons

Battery Switch

Note: The Drifter is designed to interface with Setec power supplies. The

functionality described below assumes the Drifter has been correctly connected to

such a power supply.

The Battery Switch is used to disconnect the battery from the loads.

In the off position the battery will not power the loads and “BATTERY OFF” is

displayed.

In the on position no battery annunciator is shown and the battery will power the

loads if no mains power is connected.

Note: This switch also enables/disables the USB charging port