Owner's Manual

47
3. Press any two buttons on the Switch at the same time.
Figure 43: Press any two buttons on the Switch
4. Press EXT on the Controller to accept the pairing of the Switch to the Node.
Figure 44: Press EXT to accept pairing
SWITCH
I’ve replaced the Switch in my RV, but it doesn’t work?
You need to pair the Switch to the Node before you can use the switch.
The Switch is paired to the Node in four steps:
1. Using the < or > buttons on the Controller, navigate to the ‘PA’ menu item.
Figure 41: Use < or > to navigate to the ‘PA’ menu item
2. When ‘PA’ appears on the display, press the RET button to start the pairing
process between the Switch and Node.
Figure 42: Press RET to start pairing