Product Specs
G1 Labels Product Specification
Page 22 of 30
9 Battery Replacement
9.1 Audience
Only persons with the following knowledge are allowed to replace the battery:
l Battery
l Electronic assemblies like circuit board
l Compliance of the instructions
9.2 Instructions
l Risk of explosion through incorrect battery replacement.
l Use battery pack exclusive provided from the company SES-imagotag GmbH.
l Keep attention that your hands are dry before you start with the replacement.
l Don’t use sharps to open the label.
l Don’t use your fingernails to open the label.
l Don’t touch the circuit board of the open label.
9.3 Steps
9.3.1 G1 1.6 BWR
1. Press a coin in the coin slot on the back side of the label (hidden behind the nameplate).
2. Turn the coin with pressure contraclockwise.
3. Take away the battery cover.
4. Take out the coin cell.
5. Put in the new coin cell.
6. Put the battery cover back on the label.
7. Press a coin in the coin slot on the battery cover and turn it clockwise.
8. Check if the power status of the label switch to "GOOD" otherwise contact the SES-imagotag
support (support.at@ses-imagotag.com).
9.3.2 All labels except G1 1.6 BWR
1. G1 2.2 BWR, G1 2.6 BWR and G1 2.7 BW / BWR: Press both snap-in-mounts of the battery
cover (backside of the label) until the battery cover detaches. Afterwards take the battery cover
from the label.
G1 4.2 BW/ BWR, G1 4.4 BW/ BWR, G1 4.5 BWR, G1 6.0 BWR and G1 7.4 BW /BWR: Use
the SES-imagotag battery opener tool to open the battery cover. Afterwards take the battery
cover from the label.
2. Pull the white plug out of the socket, don’t pull on the cable.
3. Take out the battery pack.
4. Put in the new battery pack.
5. Push the white plug in the socket.
6. Put the battery cover on the label casing (the arrows have to show to each other)
7. Check if the power status of the label switch to "GOOD" otherwise contact the SES-imagotag
support (support.at@ses-imagotag.com).
We can also provide some battery replacement videos, for more information about that please
contact the SES-imagotag support (support.at@ses-imagotag.com).