Quick Start Guide

Quick Start Guide
Page 21 of 50
It’s recommended for the demo installation not to use the “Auto-Config” feature and configure
the AP manually.
5.1.3 Necessary configuration over the AP-2010 web UI
The following actions need to be performed over the web-GUI
1. Deactivate Centralized Configuration: Administration -> Configuration Mode
2. Set up network details (or leave DHCP): Administration -> Network
3. Set up an ESLchannel: Administration -> Wireless Channel
The AP-2010 supports 11 ESL channels. It’s recommended to choose one of
the recommended channels: 3, 5, 8, 9 or 10. These channels do not interfere
with standard Wi-Fi channels 1, 6, 11 and are scanned by the labels more often.
For further information about selecting channels see point Connect and
configure AP-2010.
5.1.4 Necessary configuration at the imagotag Control Center
After the configuration in the AP-2010 web UI it’s necessary to add this AP via the imagotag
Control Center: System – Access Point Configuration – New … or right click on a discovered
AP- Create configuration.
FIGURE 1-17: ESL Client AP configuration - System -> Access Pont Status -> Create configuration
Choose “Manual Configuration” if you don’t use Auto-Config and enter Access Point ID (AP ID)
and IP address (Host).