Quick Start Guide

Quick Start Guide imagotag GmbH
Page 16 of 36
The AP-2010 supports 11 wireless channels. It’s recommended to choose one of
the recommended channels: 3, 5, 8, 9 or 10. These channels do not interfere with
standard Wi-Fi channels 1, 6, 11 and are scanned by the labels more often For
further information about selecting channels see point Connect and configure
Access Point AP-2010.
4.3 Necessary configuration at the ESL Client
After the configuration in the AP-2010 web management interface it’s necessary to add this AP
via the ESL Client: System – Access Point Configuration – New …
FIGURE 1-14: ESL Client AP configuration - System -> Access Pont Configuration -> New
Choose “Manual Configuration” if you don’t use Auto-Config and enter Access Point ID (AP ID)
and IP address (Host).
Note: After the basic configuration in the AP-2010 web management interface, it is also possible
to fill in AP-ID and AP-IP-Address automatically. For this choose "Create Configuration..." under
System – Access Point Status - Right click on the discovered and configured Access Point.
After saving the AP configuration you should see the AP under System – Access Point Status as
ONLINE. In addition the AP status LED should turn BLUE.