Quick Start Guide

: New versions of the imago gateway, client and access point (≥ 1.3.0) will also support old
labels that do not come with a pre-programmed PIN code. New labels (≥ 3.0.0) will also work in old
installations together with old labels but the gateway will not accept registration codes during the
registration process. To register the labels it is required to scan the barcode with the label ID from
the backside or the bottom edge of the label. As the gateway will not start the key exchange all data
is transmitted unencrypted to the labels.
It’s also possible to register labels with a commercial USB barcode scanner (2D/1D). You can also use
our iOS-App (for iPhone and iPod touch, only available on request).
Handheld terminals are mobile devices that are used to manage the ESL installation. If the handheld
provides a barcode scanner, it may be used easily to link articles and labels by scanning the article
barcode (usually EAN, UPC or GTIN) and the unique ID of the label.
Here you can see some screenshots of our iOS-App:
Figure 19: ESL-App Home-
Screen
Figure 20: ESL-App Registration
Page
Figure 21: ESL-App Matching
Page
Here are the encryption status a label could have:
AES: Communication with label is encrypted with 128 bit AES
No PIN: Could not set encryption key as no PIN (registration code) was provided
o Solution: Re-register label with registration code
Key unset: Communication is NOT yet encrypted
o Solution: Set encryption key as described in section 4 - Set encryption key
Unsupported: Encryption is not supported by label firmware
Unknown: Security status is not determined yet