Servosila-Device-Reference-0xA020192
Table Of Contents
- Servosila Device Reference
- Configuration Parameters
- Configuration - Datasheet
- Configuration - Control Laws
- Configuration - Features
- Configuration - Brake
- Configuration - Work Zone
- Configuration - Fault Management
- Configuration - Peripheral: GPIO
- Configuration - Peripheral: Hall Sensors
- Configuration - Peripheral: Quadrature Encoder
- Configuration - Peripheral: SSI/BISS-C Encoder
- Configuration - Peripheral: SPI Encoder
- Configuration - Peripheral: PWM Encoder
- Configuration - Peripheral: Gate Driver
- Configuration - Networking
- Configuration - Product Activation
- Telemetry Parameters
- Telemetry - System Status
- Telemetry - Field Oriented Control (FOC)
- Telemetry - Direct Drive Control
- Telemetry - Sensorless Observer
- Telemetry - Hall Sensors Observer
- Telemetry - Peripheral: ADC
- Telemetry - Peripheral: Hall Sensors
- Telemetry - Peripheral: Quadrature Encoder
- Telemetry - Peripheral: SSI/BISS-C Encoder
- Telemetry - Peripheral: SPI Encoder
- Telemetry - Peripheral: PWM Encoder
- Telemetry - Peripheral: GPIO
- Telemetry - Peripheral: Inverter (PWM)
- Telemetry - Peripheral: Gate Driver
- Telemetry - Networking
- Telemetry - Device Information
- Commands
- Command - Electronic Speed Control (ESC), Hz
- Command - Electronic Speed Control (ESC), RPM
- Command - Servo
- Command - Servo Stepper
- Command - Current Control / Field Oriented Control (FOC)
- Command - Electronic Torque Control (ETC)
- Command - Direct Field Control: Rotation
- Command - Direct Field Control: Electrical Position
- Command - Kickstart
- Command - Reset
- Command - Reset Work Zone
- Command - Brake
- Command - Stop
- Command - Off
- Command - GPIO: PWM output
- Command - Testing: Field Oriented Control (FOC)
- Command - Testing: Electronic Speed Control (ESC)
- Command - Testing: Servo Control
- Command - Brushed: Open Loop Control (1-2 motors)
- Command - Autoconfiguration: Brushless Motor
- Command - Autoconfiguration: Brushed Motor
- Command - GPIO: Generic Output
- Telemetry Mappings (TPDO)
- Configuration Parameters
Command - Brake....................................................................................................................................................57
Command - Stop.......................................................................................................................................................58
Command - Off.........................................................................................................................................................58
Command - GPIO: PWM output..............................................................................................................................58
Command - Testing: Field Oriented Control (FOC)................................................................................................59
Command - Testing: Electronic Speed Control (ESC).............................................................................................59
Command - Testing: Servo Control..........................................................................................................................60
Command - Brushed: Open Loop Control (1-2 motors)..........................................................................................60
Command - Autoconfiguration: Brushless Motor....................................................................................................61
Command - Autoconfiguration: Brushed Motor......................................................................................................62
Command - GPIO: Generic Output..........................................................................................................................63
Telemetry Mappings (TPDO).......................................................................................................................................64
Telemetry Message with COB-ID 0x180.................................................................................................................64
Telemetry Message with COB-ID 0x280.................................................................................................................64
Telemetry Message with COB-ID 0x380.................................................................................................................64
3 www.servosila.com