User`s manual

Note
 Always use genuine ServoGlas® front and inside cover
plates. Failure to do so may result in injury and will void
the warranty.
 The ServoGlas® 5000X is not designed for overhead
welding without the use of additional protection.
 Check your helmet for physical damage and test it
regularly. If your helmet is damaged or is not working
normally have it tested and repaired before use.
 Always select the appropriate shade before use
according to the type of welding and current/amperes
used. When in doubt refer to your authorized safety
representative.
<2 page>
Helmet and Head harness Adjustment
Please make the appropriate adjustment(s) to the head harness to ensure a
comfortable and secure fit. It only takes a minute and helps ensure you are
properly protected. The ServoGlas® 5000X harness allows you to adjust the
distance and angle between your eyes and the filter window. You can also
adjust the circumference of the headband to ensure a comfortable but firm
fit. Please make these adjustments before use based on the illustrations in
figures shown below.