User`s manual
6-4. Maintaining the Auto Lift assembly on the 5000X Auto Lift
Assembling and disassembling the Auto Lift assembly on the 5000X Auto lift is a
simple process but should be done according to the following instructions to
ensure problem free operation of the helmet.
Locate the spring (10-3L) in the recess on the outside of the helmet shell
ensuring that the end of the spring is hooked into the hole provided and pointing
upwards. Springs are handed (R/L) and if reversed the Auto Lift mechanism
will not work.
Place the spring retainer (10-2L) over the spring and ensure that the tongue of
the retainer is located in the slot provided on the side of the helmet shell.
Mount the cartridge holder assembly over the spring retainer ensuring that the
notches in the top of the spring retainer are nested into the matching slots on
the cartridge holder assembly.
Insert the slotted bolt into the hole and over the end of the spring.
While holding the slotted bolt in place with your thumb, look inside the shell and
locate the black washer over the end of the bolt which should now be visible on