User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 78
Field Description
available, the unit will not connect to the proxy server.
• Modem: The unit should only use a Modem connection. If none
is available, the unit will not connect to the proxy server.
Host/IP Fill in the IP address or hostname of the proxy server.
Port Fill in the access port of the proxy server.
Note: For full details on using this option, consult your vendor.
3. If you are using a DDNS service, under DDNS, select Enabled. The fields required to
configure the DDNS settings are added to the screen.
Figure 69: DDNS settings
Fill in the fields as follows:
Field Description
Use Select the network connection to use to connect to the DDNS service:
• Any: The unit can use any available network connection; it will
connect using the highest priority connection available (as
defined under Network Priorities; see
Network Priorities ,
page 73).
• LAN: The unit should only use a LAN connection. If none is
available, the unit will not connect to the DDNS service.
• WiFi: The unit should only use a WiFi connection. If none is
available, the unit will not connect to the DDNS service.
• Modem: The unit should only use a Modem connection. If none
is available, the unit will not connect to the DDNS service.
Type Select the type of DDNS service.
Note: If you select No-IP or DynDNS , the Username, Password,
and Confirm Password fields are added to the screen, and the
Advanced field is removed from the screen.