User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 64
4. If the unit will have a static IP address, clear the Enable Dynamic IP (DHCP)
checkbox. The fields required to configure the LAN settings are added to the screen.
Figure 50: Static IP settings
Fill in the fields as follows:
Field Description
IP Address Specify the static IP address of the unit on the cabled LAN. The
address should conform to the standards of the LAN.
Subnet Mask Modify the LAN subnet mask as necessary. The subnet mask should
conform to the one the LAN uses.
Default
Gateway
Fill in the IP address of the gateway through which the LAN connects
to the internet.
If you do not know the IP address of the gateway, consult the
network administrator or your ISP.
Note: If this field is not filled in correctly, external network services
will not be available through this network. These include accessing
the unit remotely (even through proxy and DDNS services) and SMS
and e-mail notifications.
DNS Fill in the IP address of the DNS server. A DNS server enables you to
enter names instead of IP addresses for the proxy and DDNS servers.
The DNS server may be operated by your internet provider (home
installation) or on your network (some office installations).
If you do not know the IP address of the DNS server, consult the
network administrator or the ISP.
Note: If this field is not filled in correctly, you will not be able to
specify IP addresses as host names. For example, the address of the
SMTP e-mail server will have to be defined as IP numbers. In
addition, DDNS will not perform updates if there is no valid DNS
address.
5. Click Update and then save the settings. They will be implemented after the unit is
restarted (see Saving Configuration Changes, page 139).