User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 61
Figure 47: System Restart Page after manual time updating
3. Click Restart System. The unit restarts, and the time on the unit is fully updated. You
are automatically logged out of the configuration utility, and a confirmation message
appears:
Sync Time confirmation messa
g
e
NOTE: If the unit clock was set ahead more than about 15 minutes, the screen may display a
message indicating that your configuration session has expired instead of the
System
Restar
t page. This does not mean that the time was not reset correctly. However,
you should still restart the unit to fully implement the update. To do this:
• Log into the configuration utility again.
• If you made changes to other configuration settings before you updated
the time, and did not yet save them on the unit (i.e., you clicked
Update in one or more of the screens, but did not yet save the changes
in the
Save Settings page), navigate to the Save Settings page, click
Save Changes to System, and then, in the
System Restart page, click
Restart System.
If you do not need to save any other changes, navigate directly to the
System Restart page and click Restart System.
For additional information, see Saving Configuration Changes,
page 137.