User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 56
Field Description
Video mode Select the video format used by the monitor.
Note: Some SECAM monitors are compatible with the system. If
they are, they should work when the PAL video mode is
selected.
Display type Select the desired layout for the video display on the monitor:
• Split Screen: Divides the screen so that video from all
the cameras is visible all the time
• Full Screen – Camera #: Displays video from the
specified camera in full-screen mode
• Full Screen – Rotate: Loops through all of the
cameras, displaying each in full-screen mode for the
number of seconds specified under Rotate delay
Rotate delay If you selected the Full Screen – Rotate display type, specify
the number of seconds you want the video from each camera
to be displayed before it is replaced with video from the next
camera.
Display Switch Via
Sensor
Select this option if Sensor 4 is a switch that you want to use to
cycle through the various display types.
Note: This option is only fully activated if it is selected here and
configured in the Sensor 4 configuration screen, as described
under
Configuring Sensor 4 to Control CCTV Display , page 123.
Cameras Select the cameras that will be accessible via the monitor.
Cameras that are not selected do not appear in the monitor at
all. Video from these cameras cannot be viewed on the monitor
and the cameras cannot be configured through the monitor.
Display Camera
Name in Live Video
Select this option if you want the name of the camera to be
displayed in the camera pane when video is played on the
monitor.
Note: Displaying names on the monitor requires extra system
resources and may impede performance.
Note: If both this option and Display Camera Number (see
below) are selected, the index of the camera (1, 2, 3, or 4) is
displayed instead of its name.
Display Camera
Name in Playback
[Not currently in use.]
Display Timestamp
in Playback
[Not currently in use.]