User guide

SerVision MVG 400 System Guide

Configuring the MVG 400 54

To configure the volume of a microphone:

1. Open the client application for which you want to optimize the settings (e.g., the

MultiClient), connect to a live video stream that is linked to the microphone, and listen to

the sound. If the volume needs adjustment, adjust it as explained in the following steps.

2. In the

General System Settings screen, under Audio In, select a volume setting for the

relevant microphone (“CH 1” for Ain1; “CH 2” for Ain2).

Figure 39: Microphone volume settings

3. Click Update Now (see figure 38 on page 53). The volume settings are updated on the

MVG 400 immediately.

Note: All of the settings on the page are saved when you click Update Now. The volume

settings are implemented immediately, and the changes to the other settings are

implemented after the unit is restarted (see Saving Configuration Changes, page 139). If

you modify the volume settings and click the Update button in the lower-right corner of

the screen, the volume settings are not implemented until the unit is restarted.

4. In the client application, listen to the audio from the video stream that is linked to the

microphone.

5. Repeat steps 2–4 as necessary until the optimal volume setting is selected.

Configuring a CCTV Monitor (TV-Out)

If a video monitor is connected to your MVG 400, you must activate and configure it before

you can see video from the MVG 400 on it.

NOTE: For additional information about setting up a CCTV monitor and viewing video on

it, see Connecting a CCTV Monitor, page 24; Viewing Video on a CCTV Monitor

(TV-Out), page 152.

To enable and configure a CCTV monitor:

1. In the Main Menu, under System, click TV-Out. The TV-Out Settings screen opens: