User guide

SerVision MVG 400 System Guide

Configuring the MVG 400 53

You can test the volume settings as you configure them by connecting to the MVG 400 using

a client application. Volume levels can be adjusted for testing purposes without resetting the

MVG 400 unit.

To configure the volume of the internal speaker:

1. Make sure someone is near the MVG 400 to listen to sound being transmitted from the

speaker.

2. Using a client application that can transmit audio to a video gateway (the MultiClient

and the Symbian S60 cell-phone client applications), connect to the MVG 400.

3. Speak into the microphone of the client device and check with the listener to find out if

the volume is appropriate. If it is not, adjust the settings as described below until they are

satisfactory.

4. In the

General System Settings screen, under Internal Speaker Volume, select a

volume setting.

Figure 37: Speaker volume settings

5. Click Update Now. The volume settings are updated on the MVG 400 immediately

Figure 38: Update Now button

Note: All of the settings on the page are saved when you click Update Now. The volume

settings are implemented immediately, and the changes to the other settings are

implemented after the unit is restarted (see Saving Configuration Changes, page 139). If

you modify the volume settings and click the Update button in the lower-right corner of

the screen, the volume settings are not implemented until the unit is restarted.

6. Repeat steps 3–5 as necessary until the optimal volume setting is selected.

Update Now

0 1 2 3 4 5 6 7 8 9 10

Reduced volume No change Increased volume