User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 51
Field Description
GPS Recording Select this option to record the results of each GPS location
check. This option must be selected it you want to be able to
see the route followed by the vehicle, or see where the vehicle
was when a particular event occurred.
Note: Clearing this option does not free disk space for other
uses.
Ignition Select this option if you want the unit to power down
automatically whenever the ignition is turned off. If you do not
select this option, the unit operates continuously as long as it
has a power supply.
Note: This setting only affects the unit if the unit is connected
both directly to the battery and to the ignition. Otherwise, the
unit operates continuously as long as it has a power supply
(see
Connecting the Unit to the Vehicle Battery , page 29).
Ignition Countdown Select the amount of time that the unit should continue
operating after the vehicle ignition is turned off, in seconds.
Note: This setting only affects the unit if the unit is connected
both directly to the battery and to the ignition. Otherwise, the
unit operates continuously as long as it has a power supply
(see
Connecting the Unit to the Vehicle Battery , page 29).
Note: This field only appears if the Ignition checkbox is
selected.
Stop Recording on
Download
Select this option to stop all video recording when video is
being downloaded from the MVG 400.
Accept New
Connections while
Downloading
Select this option to enable the streaming of new live or
recorded video streams to a client application while
downloading of recorded video to a PC is taking place.
Video Authentication Select this option if you want the system to include a digital
signature in each video frame streamed and/or recorded by the
unit. The signature can be used to identify streams that were
tampered with.
Note: This option increases the load on the system resources
slightly, so it is advisable to activate it only if it is truly required.