User guide

SerVision MVG 400 System Guide
Installing the MVG 400 System 32
D
D
D
To connect the MVG 400 to the vehicle’s cigarette lighter:
• Use the supplied power cord to connect the Power connector on the rear panel of the unit
to the vehicle’s cigarette lighter.
Figure 20: Power cord
Connecting the Unit to an Electrical Outlet
If a standard electrical outlet is available, the unit can be connected to it. For example, if you
want to configure or test the unit indoors, you can power the unit in this way. The power-
supply cable has a built-in switch. The switch mimics the ignition switch of a vehicle: when
the switch is in the ON position, the "ignition" is on, and when it is in the OFF position, the
"ignition" is off.
WARNING: Only the power supply cable that came with the unit should be used to
connect the unit to an electrical outlet. Use of a power supply other then the
one provided in the package may cause irreparable damage to the unit.
D
D
D
To connect the MVG 400 to a standard electrical outlet:
1. Use the supplied power supply cable to connect the Power connector to the outlet.
Figure 21: Power supply cable
2. Push the switch on the cable to the ON position. The "ignition" is on.
Switch
Connect to the electrical outlet
Connect to the
Power connector
on the MVG 400