User guide

SerVision MVG 400 System Guide

Installing the MVG 400 System 30

this way is also only recommended for limited periods of time for testing and evaluation

purposes.

NOTE: The ignition connector (IGN) of the Power connector MUST be connected. If it is

not, the unit will not start. If you wish to use the vehicle’s ignition connection,

connect it to this connector. Otherwise, short this connection to the power (+)

connector. For additional information, see step 5 below (pp. 31–31).

NOTE: To connect the unit only to the battery, 16 AWG red and black cable (not supplied)

is required.

To connect the MVG 400 to the vehicle battery:

1. Remove the wire connector from the end of the supplied power cord.

Figure 16: Wire connector

2. Plug the wire connector into the Power connector on the rear panel of the unit and

tighten the screws to secure it.

Figure 17: Wire connector plugged into Power connector

3. Using 16 AWG red cable, connect the unit to the vehicle battery as follows:

• Connect one end of the red wire to the positive (+) connector of the Power wire

connector (the middle connector in the block).

• Connect the other end of the red wire to the positive (+) connector of the vehicle

battery or power source

4. Using 16 AWG black cable, connect the unit to the vehicle battery as follows:

Wire connector