User guide

SerVision MVG 400 System Guide
3
Table of Contents
Introduction 5
About Client Software 5
The MVG 400 Package 6
Additional Equipment 8
Installing the MVG 400 System 10
Installing the Unit 11
Diagram of the Rear Panel 12
Connecting Devices to the MVG 400 14
Connecting Cameras 15
Connecting Sensors 17
Connecting Activators 22
Connecting Microphones 23
About Speakers 23
Connecting a CCTV Monitor 24
Setting Up Network Connections 25
Connecting the MVG 400 to an External Network 26
Connecting Devices to the MVG 400’s Internal Network 27
Connecting the GPS Antenna 28
Connecting the MVG 400 to a Power Source 28
Connecting the Unit to the Vehicle Battery 29
Connecting the Unit to an Electrical Outlet 32
Installing the MultiClient 33
Opening the MultiClient 34
Configuring the MVG 400 36
Before You Begin 36
About the Configuration Utility 36
Opening the Configuration Utility 37
Overview of the Interface 39
Using the Configuration Utility 41
Opening the Configuration Remotely 44
Opening the Configuration Manually 45
System Settings 46
General System Settings 47
Configuring a CCTV Monitor (TV-Out) 54
Setting the Unit Time 57
LAN Settings 63
Modem 65
WiFi 68
Network Priorities 73
Port Forwarding 74
Proxy and DDNS Settings 76
Authentication 80