User guide

SerVision MVG 400 System Guide
Installing the MVG 400 System 28
Setting Value
IP Address Assign a static IP address to the device. The IP must be in the range
172.20.233.2 through 172.20.233.99.
Mask
255.255.255.0
Gateway
172.20.233.1
DNS
172.20.233.1
Connecting the GPS Antenna
A GPS receiver is built into the unit. When the GPS antenna is connected to the unit, this
receiver can be used to track the location of the vehicle in which the MVG 400 is installed.
D
D
D
To connect the GPS antenna:
1. Connect the supplied GPS antenna cable to the GPS connector on the rear of the unit.
2. Place the other end of the antenna as high up as possible in the vehicle, such that there
are no obstructions between it and the sky. The end of the antenna contains a magnet
with which you may be able to attach it to the roof of the vehicle. Alternatively, you can
attach it to its intended location with double-sided tape. In any case, make sure the
antenna is attached securely to the vehicle so that it will not come loose when the vehicle
moves.
Connecting the MVG 400 to a Power Source
The power connector of the MVG 400 can be connected either to the vehicle battery or to a
standard electrical outlet. Once it is connected, it starts up automatically. During the start-up
process, the LEDs on the front of the unit flash at various intervals. When the start-up process
is completed successfully, the Power LED should display as a solid color and blink
momentarily every second. (Depending on the configuration settings, it should either be solid
orange and then blink green or solid green and then blink orange.)