User guide

SerVision MVG 400 System Guide

Installing the MVG 400 System 19

• Flat ribbon cable with D-type 9-pin female connector on one end and a D-type 9-pin

male connector on the other end

• Wire to connect the ADAM module to the ADAM converter – red, black, yellow, and

green

• Wire and an electrical plug (optional) to connect the ADAM module to a power source

(either a power supply from the unit or an independent connection)

Figure 8: ADAM-4051 module

Figure 9: ADAM-4520 isolated converter

NOTE: The instructions below explain how to connect sensors to the MVG 400 using the

ADAM module and converter described above. For additional information about

connecting and configuring the ADAM module and converter, please refer to the

manufacturer's documentation, or contact your vendor.

To connect sensors using an ADAM module:

1. Install the sensors in their desired locations in accordance with the manufacturer's

instructions.

2. Connect the wire contacts of each of the sensors to the terminal blocks of the ADAM-

4051 module as follows:

• Connect all of the negative (-) wires of all of the sensors to one of the ground (D

GND) connectors on the ADAM module. If the wires cannot all be inserted into

the connector, use a wire connector to connect them together, and then connect the

wire connector to the ground (D GND) connector on the ADAM module.

• Connect each of the positive (+) sensor wires to one of the numbered connectors

(D1 0 through D1 15) in the terminal blocks of the module.