User guide

SerVision MVG 400 System Guide
Resetting the Unit 154
Resetting the Unit
You can reset the unit at any time. Resetting the unit may help if video streaming is unreliable
or frequently interrupted. If changes were made to the configuration of the unit (see
Configuring the MVG 400, page 36), and the changes were saved on the unit, but the unit was
not reset afterwards, the changes are implemented when the unit is reset.
The unit can be reset in one of three ways:
• Software: Selecting Restart in the configuration utility, as described below
• Reset button: Pressing the Reset button located on the back of the unit (use a pin or
similar implement to press the button)
• Power Reset: Unplugging the unit from the power and then plugging it in again
If the unit cannot be accessed through the local network, you can restore its factory settings
and then access the unit as described under Opening the Configuration Utility, on page 37.
D
D
D
To reset the unit using the configuration utility:
1. Log into the configuration utility (see Opening the Configuration Utility, page 37).
2. In the
Main Menu, under System, click Restart. The System Restart Page opens:
Figure 146: System Restart Page
3. Click Restart System. The unit restarts. You are automatically logged out of the
configuration utility, and a confirmation message appears: