User guide

SerVision MVG 400 System Guide
Viewing Video on a CCTV Monitor (TV-Out) 153
The default display is defined in the unit’s configuration (see Configuring a CCTV Monitor
(TV-Out), page 54). If a switch is connected to the Sensor 4 connector on the rear panel of the
unit, you can use the switch to cycle through the various available display types (see Sensor
and Activator Settings, page 115). Otherwise, the default display is always used.
NOTE: In order for the monitor to work, TV-Out must be activated in the unit’s
configuration. For additional information, see Configuring a CCTV Monitor (TV-
Out), page 54.
When the MVG 400 unit starts up, the monitor displays a startup screen containing the name
of the unit, the IP address
0.0.0.0, the net mask, the firmware version, and a video pane
displaying live video from one of the cameras connected to the unit. After a few seconds, this
display is replaced by the default video display.
Figure 145: Startup screen
NOTE: The IP
0.0.0.0 is displayed because the unit's internal DHCP server has not yet
assigned an IP address to the unit. You can see the correct IP address in the
configuration utility on the Port Forwarding page (see Port Forwarding, page 74).
Note that this is the IP address of the video gateway component of the unit in the
local network managed by the unit's router.
NOTE: If the unit is configured to connect to an external LAN using DHCP (see LAN
Settings, page 63), [DHCP] appears after the 0.0.0.0 in the IP field.