User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 143
Figure 133: Confirm Restore screen
3. Select Are you sure you want to restore factory defaults?.
Note: If you do not select this option, the unit's settings will not be restored, even if you
click Confirm.
4. If you want to save all the recorded video that is stored on the unit, select Attempt To
Save Recordings?. Before restoring the factory settings, the system will attempt to save
the recorded video on the hard drive. If it succeeds, the video will be available on the
unit after the factory settings are restored. The names of the unit and of the cameras
recording the video will be lost, however; the cameras will be identified as Camera 1,
Camera 2, etc.
Note: Normally, the video can be saved if two conditions are met: (1) The recordings
were all in SIF resolution. (2) The disk space allotted to each camera for storing video
recordings matched the default allotment (24% for each camera; see Advanced Recorder
Settings, page 112).
5. Click Confirm. The default factory settings of the unit are restored, and the
System
Restart Page
screen opens.