User guide

SerVision MVG 400 System Guide
Installing the MVG 400 System 14
Connector/Control Description
Reset Reset button. Use a pin to press the button when it is necessary
to reset the unit manually.
Note: Your configuration settings will not be lost during a reset.
Power Connector for the power supply and, if required, for the ignition
connection (see page 28)
Audio Out (Aout) Connector for an external speaker or headphones (see page 24)
Audio In2 (Ain2) Connector for an active microphone (see page 23)
Audio In1 (Ain1) Connector for a passive microphone (see page 23)
TV Out Connector for a CCTV monitor (see page 24)
Video In (Vin1–Vin4) Connectors for video cameras (see page 15)
Ethernet Cable Cable connecting the video gateway component of the MVG 400
to the unit’s router. Do not disconnect.
RS232/485 Serial (COM) port for PTZ controllers (see page 16), ADAM
modules (see page 18), and/or technicians' use
12VDC Power Out Supplies power to external devices (cameras, sensors, etc.)
Note: The unit can supply up to 500 mA of power.
USB Ports Connectors for WiFi cards or cellular modems with USB adaptors
(see pages 65 and 68)
Inputs (In1 – In4) Sensor connectors (see page 17)
Ethernet (Out) 10/100 Base-T LAN connector for connecting the unit to an
external network (LAN or WAN; see page 26.)
Ethernet (In) Three 10/100 Base-T LAN connectors for connecting other
devices to the internal network managed by the router (see
page 27)
GPS GPS antenna connector
Outputs (Out1, Out2) Activator connectors (see page 22)
Connecting Devices to the MVG 400
This section explains how to connect cameras, sensors, activators, microphones, a speaker or
headphones, and a CCTV monitor to the MVG 400 unit.