User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 129
NOTE: Sensor and schedule-based outline switching override manual outline selections
and the start-up outline. For example, if Sensor 1 is configured to function as an
outline switch, and the "Daytime" outline is selected for activation when the
Sensor 1 is off, the “Daytime” outline will load automatically whenever the outline
switch is in the OFF position. If the Default outline is selected for start-up, it will
be replaced immediately after startup by the "Daytime" outline. For additional
information, see Configuring Sensor 1 to Switch Outlines, page 121; Schedules,
page 129.
D
D
D
To manually switch the running outline:
• In the Outlines screen, in the line in which the outline is listed, or in the relevant outline
configuration screen, click Activate. The selected outline runs immediately. If the
Outlines screen was not already opened, it opens and displays an updated summary of
the outline settings.
D
D
D
To select the start-up outline:
1. In the Outlines screen, in the line in which the outline is listed, or in the relevant outline
configuration screen, select Load Outline on System Start.
2. Click Activate (to the right of the checkbox). The selected outline runs immediately, and
is selected as the start-up outline that will be loaded automatically whenever the system
starts. If the
Outlines screen was not already opened, it opens and displays an updated
summary of the outline settings.
Schedules
Schedules allow you to configure the unit to automatically switch the running outline at
specified times. You can set up standard repeating schedules for routine time periods, such as
regular work weeks or the summer months. You can also define special schedules for
holidays, both repeating holidays (e.g., New Years Day) and non-repeating holidays (e.g., a
presidential visit or the opening ceremony of the Olympics).
The schedule is only implemented by the system if the following conditions are met:
• Multiple outlines are defined for the system (see Outlines, page 124)
• Schedule-triggered outline-switching is activated in the
General System Settings screen
(see General System Settings, page 47)
D
D
D
To configure the schedule:
1. In the Main Menu, under System, click Schedules. The Schedules screen opens. If
schedule-triggered outline switching is not activated in the
General System Settings
screen, Inactive appears in parentheses after the name of the screen. In this case, you can
configure the schedule, but it will not be implemented unless you activate schedule-
triggered outline switching.