User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 128
Figure 115: Device that is not enabled in the Default outline
6. Select the desired settings for the device in the current outline.
Note: For information about the settings, please refer to the section of this manual that
relates to each type of setting, as follows:
• Video Motion Detection (VMD), page 101
• Configuring Video Lost, page 108
• Video Recording Settings, page 110
• Sensor and Activator Settings, page 115
Note: In the Camera screens, when recording is by event, the sensors and activators can
only be selected as triggers if they are already enabled in the current outline. Thus, for
example, if you want to select Sensor 1 as a trigger for the Camera 1 recorder, you must
first enable Sensor 1 in its configuration screen, and then select it in the Camera 1
configuration screen.
7. Click Update.
8. Repeat steps 5–7 for each of the cameras, sensors, and activators connected to the
MVG 400.
9. Save the changes. The settings will be implemented after the unit is restarted (see Saving
Configuration Changes, page 139).
Activating Outlines Manually
If more than one outline is defined, you can manually select the outline you want to run at any
time. When you do, you can also specify that the selected outline be loaded automatically
when the unit first starts up. In this case, the selected outline replaces the Default outline as
the system default.