User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 124
Figure 108: Sensor #4 configuration screen
Note: Every time the CCTV display is switched, a sensor event is triggered. If
notification settings are activated, notifications will be triggered each time the display is
changed.
2. Select the TV-Out Display Switch checkbox.
3. Click Update, and then save the settings. They will be implemented after the unit is
restarted (see Saving Configuration Changes, page 139).
Outlines
Outlines define alternate sets of recording and event-handling settings. For example, you
could define one set of settings for times when the vehicle is in operation and another set for
when it is parked; when the vehicle is in operation, the motion and sensor notifications would
be turned off, but when it is parked, they would be turned on.
Outline configuration is an optional feature of the MVG 400. If you do not define any
outlines, all the event-handling settings are automatically stored in the Default outline. You
do not have to configure the outline settings at all in this case. If you choose to use the
Outline feature, you can define up to five additional outlines.
When multiple outlines have been defined, the running outline – the outline whose settings
are currently being used by the system – can be switched in one of three ways:
• Manually: By selecting the desired outline in the configuration utility, as described
below
• Sensor: In response to sensor events on Sensor 1 (toggling of a switch connected to In1)
• Schedule: According to a predefined schedule
The Sensor and Schedule alternatives are mutually exclusive; only one of these two automatic
switching methods can be active at any given time. That is, for example, when switching is
triggered by toggling the Sensor 1 switch, it cannot also be triggered by a schedule. The active
outline-switching method is selected in the
General Systems Settings screen (see page 52).