User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 122
NOTE: This feature can only be activated in the Sensor 1 configuration screen if it is first
enabled in the General System Settings screen (see General System Settings,
page 47).
D
D
D
To configure Sensor 1 as an outline switch:
1. In the Main Menu, under Sensors, click Sensor 1. The Sensor #1 configuration screen
opens.
Figure 105: Sensor #1 configuration screen
Note: Every time the outline is switched, a sensor event is triggered. If notification
settings are activated, notifications will be triggered each time the display is changed.
2. Under When Sensor On, under Load Outline, select Enable. The Outline field is
added to the screen.
Figure 106: Outline field
3. In the dropdown list, select the name of the outline you want to load when the toggle
switch is turned on.