User guide

SerVision MVG 400 System Guide
Installing the MVG 400 System 12
Figure 2: Supports attached to bottom of the MVG 400
2. Place the unit in the desired location and attach it securely by connecting the side
supports to the anchoring surface with two or three screws on each side. (These screws
are not included with the MVG 400.)
Note: The unit can be placed horizontally or vertically. If it is placed vertically, it does
not matter which side faces up.
Diagram of the Rear Panel
The rear of the MVG 400 unit contains the connectors and controls described below.
Side support
Screw and washer
MVG 400 body