User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 117
configured in the Sensor #2 configuration screen, and so forth. Sensors connected to the unit
through an ADAM module appear as “External Sensors.” They are configured in the same
way as sensors connected directly to the unit.
NOTE: External sensors can only be enabled and configured if ADAM Sensors is enabled
in the General System Settings screen (see Configuring General System Settings,
page 48).
The sensor and activator configuration screens are accessed from the Sensor Summary
screen.
D
D
D
To open the Sensor Summary screen:
• In the Main Menu, click Sensors.
D
D
D
To configure a sensor or activator:
1. In the Main Menu, under Sensors, click the sensor or activator (e.g., Sensor #1 to
configure the sensor plugged into In1). The relevant
Sensor or Activator configuration
screen opens:
Figure 103: Sensor configuration screen
2. Select the Enabled checkbox. The fields required to configure the sensor or activator
settings are added to the screen.