User guide

SerVision MVG 400 System Guide
Installing the MVG 400 System 11
NOTE: Installing the unit and its peripheral equipment in a vehicle is a complex process. It
is highly recommended that it be performed by a trained specialist in vehicle
installations.
Installing the Unit
The unit should be installed in a cool and ventilated location, protected from direct sunlight
and water. It should be firmly secured to ensure it does not move around when the vehicle is
in motion; if the unit is dislodged from its location in the vehicle, it may be damaged, hit
people in the vehicle, or harm other items with which it comes into contact.
Ensure the unit has at least a few centimeters (1–2 inches) of space above it and on all sides
for ventilation.
When choosing a location for the MVG 400, bear in mind that the unit must be connected to
the vehicle battery and ignition (if required), and that other devices (cameras, sensors, PC,
etc.) must be connected to it. Choose a location in which these connections are feasible.
NOTE: To install the unit in the vehicle, you will need screws to secure the unit to its
anchoring surface (not supplied; see step 2 below).
D
D
D
To install the MVG 400:
1. Connect the two side supports to either side of the bottom of the MVG 400, using two
screws and two washers for each support. (The screws and washers are included with
the MVG 400.)
Figure 1 - Side support