User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 108
Field Description
Activator 1
Activator 2
Select the action that each activator should perform when a motion
detection event begins:
• Turn on: Set the activator line to “high.”
• Turn off: Set the activator line to “low.”
• None: Do not change the activator’s setting.
Note: For additional information about working with activators, see
Sensor and Activator Settings , page 115.
Go To Preset All PTZ cameras connected to the MVG 400 that support presets are
listed below this heading. If you want one of these cameras to
automatically aim at a preset location when a motion detection event
begins, beside the name of the camera, select the number of the
preset location.
Note: Preset locations are defined and assigned numbers using a
client application such as the MultiClient. For additional information,
please refer to the relevant client application guide.
Note: If no PTZ cameras are connected to the unit, this field does not
appear.
11. Under On Motion Ended, select the actions that the MVG 400 should perform when a
motion detection event ends, as described above.
Configuring Video Lost
The MVG 400 monitors the camera connections. If the video signal from a camera is lost –
i.e., the MVG 400 is not receiving video from it, either because of a malfunction in the
camera, or because the camera has been disconnected from the unit or from its power source –
the unit can respond in any or all of the following ways:
• Upload video of the event to an ftp server on the internet (see Automatically Uploading
Video to an AVV Server, page 87). If e-mail notification recipients are defined in the
SMS
and E-mail
screen, an e-mail message is sent to all the recipients when the Video Lost
event begins and a second e-mail is sent when the video is successfully uploaded and is
available for downloading by users. Each e-mail notification includes a link to the video
file on the server and a picture of the event.
• Send event notifications to the SMS and/or e-mail recipients defined for the system (see
SMS and E-mail Notifications, page 81). E-mail notifications can optionally include a
picture of the event, and, if AVV is activated, a link to video of the event.
• Turn an activator on or off.
• Move any PTZ camera connected to the MVG 400 that supports presets to a preset
location.
These actions can be implemented when the event begins, when it ends, or both.