User guide

SerVision MVG 400 System Guide
Configuring the MVG 400 100
Figure 91: Audio recording settings
Figure 92: Audio-recording enabled message
6. In the audio-recording enabled message, click OK.
7. If you do not want audio from the microphone to be incorporated with the video recorded
from the camera, under Audio Recording, clear the Enabled checkbox.
Note: The Audio Quality field is not currently in use. All audio recordings have
medium quality.
8. If you want to use the MVG 400’s VMD features to detect and respond to motion in the
camera’s field of view, under Motion Detection (VMD), select Enabled. Then follow
the instructions below (Video Motion Detection (VMD), page 101).
Note: Be aware that on PTZ-controlled cameras each change of the camera position is
interpreted by the VMD system as an event.
9. Configure the unit's response to interruptions in the transmission of the video signal from
the camera to the unit as described below (Configuring Video Lost, page 108).
10. Configure the camera’s recorder as described below (Video Recording Settings,
page 110).
11. Click Update. Changes to brightness, contrast, and saturation are implemented
immediately. Save the settings to implement them permanently; save the settings and
restart the unit to implement all other changes (see Saving Configuration Changes,
page 139).
Configuring PTZ
This section explains how to configure the pan-tilt-zoom (PTZ) controls of cameras that
support these features. Once the controls are configured, the camera can be aimed and
zoomed remotely using any of the client applications.
NOTE: For information about connecting the PTZ controller to the MVG 400 unit, see
page 16.