Installation guide

PVN SerVision
HVG400 Installation Guide
Installing the HVG400 System
8
Audio In1 (Ain1)
TV Out
Audio In2 (Ain2)
Audio Out (Aout)
Power
Reset
Video In
Vin1–Vin4
Ethernet Out
RS232/485
Mouse Connector
Audio M ute
Sensors
In1–In6
Activators
Out1, Out2
Figure 1: HVG400 connectors and controls
Connector/Control
Description
Reset
Reset button. Use a pin to press the button when it is necessary to
reset the unit manually.
Note: Your configuration settings will not be lost during a reset.
Power
Connector for the power supply (see page 21)
Audio Out (Aout)
Connector for an external speaker or headphones (see page 17)
Audio In2 (Ain2)
Connector for an active microphone (see page 17)
Audio In1 (Ain1)
Connector for a passive microphone (see page 17)
TV Out
Connector for a CCTV monitor (see page 18)
Video In (Vin1–Vin4)
Connectors for video cameras (see page 9)
Ethernet Out
10/100 Base-T LAN connector for connecting the unit to an external
network (LAN or WAN; see page 20)
RS232/485
Serial (COM) port for PTZ controllers (see page 9), ADAM modules (see
page 11), or technicians' use
Mouse Connector
Mouse connector (for the supplied PS2 mouse only; see page 18)
Audio Mute
Switch to turn the internal speaker on or off (see page 17)
Sensors (In1 – In 6)
Sensor connectors (see page 10)
Activators (Out1, Out2)
Activator connectors (see page 15)