Installation guide

PVN SerVision
HVG400 Installation Guide
Connecting the HVG400 to a Power Source
21
Connecting the HVG400 to a Power Source
The HVG400 must be connected to a standard wall outlet using the supplied power supply cable. Once it is
connected, it starts up automatically. During the start-up process, the LEDs on the front of the unit flash at various
intervals. When the start-up process is completed successfully, the Power LED should display as a solid color and
blink momentarily every second. (Depending on the configuration settings, it should either be solid orange and then
blink green or solid green and then blink orange.)
Power LED
Figure 15: Power LED
NOTE: When the start-up process is completed, if the Power LED does not flash – it displays as a solid green
or orange all the time – the start-up process was not successful. In this case, disconnect the unit from
the power supply and then reconnect it.
Warning: Only the power supply cable that came with the unit should be used. Use of a power supply other
then the one provided in the package may cause irreparable damage to the unit.



To connect the HVG400 to a power source:
 Connect the Power connector on the rear panel of the HVG400 unit to a standard wall socket using the
supplied power supply cable (see The HVG400 Package, page 5). The unit starts up.