Operator`s manual

OPERATION
TX165A,135A,115A 02/11 Operation Section 4-12
© 2011 Alamo Group Inc.
OPERATION
6.1 Cutting Height Adjustment
1. Using the tractor hydraulics, raise the mowers
off the ground and support under it with secure
blocking so not to let the mower drift down
during maintenance.
2. Holding wheel and yoke assembly up, remove
quick-lock pin from top of gauge wheel spindle.
Position full length spacers and 1/4" spacer as
required. All spacers on top of spindle tube
allows for approximately 1/2" cutting height.
Adjustments range from 1/2" to a maximum of
5" in 1/4" increments.
3. For the 11' Model Shaft Height Adjustment
remove quick-lock Pin from top of Shaft.
Remove Shaft from Axle Arm. Position full
length Spacers and half Spacers as required.
All spacers on top of spindle tube allows for
approximately 1/2" cutting height. Adjustments
range from 1/2" to a maximum of 5" in 1/4"
increments.
ROLLER ADJUSTMENT
Place roller brackets in lowest position for cutting
heights 5” to approximately 3”. Place in highest
position for 1” approximately 1-1/2” cutting heights.
Place in intermediate position for cutting heights 2”
to approximately 3”.